Carrier Access Access Navigator - Manual (Page 453)

Access Navigator - Release 1.8 August 2003 17-19
Update Controller Card Software
Information and Materials Required
Information and Materials Required
Obtain the following items.
l Office records for installation site
l User name (if required)
l Password (if required)
l Update software file for Controller
Verify Equipment Status
1. If you are not currently logged into the Access Navigator, start an RS-232 management session.
2. Verify current Controller status and software version with following command:
status equipment
A message similar to the following will appear, showing the Controller cards installed and the
software version.
Equipment Status Version
--------- ------ -------
Controller A Active 01.77
Controller B Card not installed
DS1 Card 1 Installed 1
DS1 Card 2 Installed 1
DS1 Card 3 Installed 1
DS1 Card 4 Installed 1
DS1 Card 5 Installed 1
DS1 Card 6 Installed 1
DS1 Card 7 Card not installed 1
DS1 Card 8 Card not installed 1
Active Standby
------ -------
SW Build Number 17701
Boot Code Revision 01.09
FPGA Code Revision 1.06
Requirement: Controller is “Active”.
Requirement: Controller shows old software version.
WARNING! D O NOT CONTINUE THIS PROCEDURE IF THE C ONTROLLER V ERSION IS
01.70 UP TO AND INCLUDING 01.80 OR IF THE B OOT C ODE R EVISION IS 01.07 OR
01.08. U SE THE UPGRADE PROCEDURE IN P RODUCT T ECHNICAL N OTE PTN-03-004,
AVAILABLE BY CALLING C ARRIER A CCESS C USTOMER S UPPORT AT (800) 495-5455.