Set ds1 remote device mgmt, Set ds1 remote device mgmt -112, See set ds1 remote device mgmt on – Carrier Access Access Navigator User Manual
Page 569: Ee set ds1 remote device mgmt on
Access Navigator - Release 1.8
August 2003
18-113
CLI Language Reference
CLI Command List
Set DS1 Remote Device Mgmt
Purpose:
Sets the remote device management type for the management channel.
NOTE:
CA FDL management requires a Type 2 T1 line with ESF framing
and FDL capability. If FDL facilities are not available, CA IP management can
be used instead to send IP packet data over a DS0 channel in the drop DS1.
NOTE:
When remote device management is enabled (any setting except
none), the DS1 FDL protocol must be set to none. See Set DS1 FDL on
NOTE:
The Access Navigator only supports P-Phone service between a
remote Adit 600 terminal and a Nortel DMS switch (see Set Switch Type on
). The Access Navigator must be configured for Carrier Access IP
management (CAIP) with P-Phone service (pphone) enabled so that the IP
DS0 channel can also carry P-Phone management data.
Security:
Level 2 (operator)
Syntax:
set ds1
Syntax:
set ds1
Example:
set ds1 10 remote device mgmt cafdl
This will affect 'remote device management' for a remote
device using CAIP.
Are you sure you want to change the management type (y/n)?
Example:
set ds1 11 remote device mgmt ds1 10
Example:
set ds1 13 remote device mgmt caip 192.168.3.158
Example:
set ds1 14 remote device mgmt caip 192.168.3.159 pphone
Field
Description
n
DS1 number, 1 to 32, or a range of numbers such as 2-8.
cafdl
Set to Carrier Access FDL management channel.
caip ipaddr
Set to Carrier Access IP DS0 management channel.
ipaddr is the IP address of the remote device in the form
xxx.xxx.xxx.xxx, where xxx is a number from 0 and 255.
ds1 n
Set remote device DS1 to point to the management DS1.
There can be only one management DS1 on a remote device, so
all other DS1s must be set to point to the management DS1.
none
Turn off Carrier Access remote management.
pphone
Enables P-Phone management channel to a remote Adit 600.
Note: The Access Navigator must also be conected to a Nortel
DMS switch (see Set Switch Type on
).