Carrier Access Access Navigator - Manual (Page 497)

Access Navigator - Release 1.8 August 2003 18-41
CLI Language Reference
CLI Command List
Log Config
Purpose: Displays configuration log events. The Access Navigator maintains a log of the most
recent 500 configuration changes in a separate log file. The log also records the
management interface port used to make the changes. The Config log file will be erased
by a power interruption, clear config log command, reset command, or
restore
defaults command.
Security: Level 3 (monitor)
Syntax: log config
Displays all configuration log events.
Syntax: log config ds0 <n:ch>
Displays only the configuration management events affecting a DS0 channel or range
of channels.
Syntax: log config ds1 <n>
Displays only the configuration management events affecting a DS1 or range of DS1s.
Syntax: log config crv <value>
Displays only the configuration management events affecting a CRV or range of
CRVs.
Syntax: log config source <cli|eoc|snmp|icc>
Displays only the configuration management events from a management interface.
Example: log config ds0 10:5
Field Description
n DS1 number, 1 to 32
ch DS0 channel, 1 to 24
value Call Reference Value, 1 to 768
cli Command Line Interface using RS-232 port or Telnet Ethernet
port.
eoc Embedded Operations Channel using GR-303 DS1 interface
group connected to a switch.
snmp Simple Network Management Protocol using Ethernet port.
(SNMP is used by MIB browsers and other management
software.)
icc Internal Controller Communication. Lists controller events that
occurred while this Controller card was in standby.