Carrier Access Access Navigator - Manual (Page 378)

15-36 August 2003 Access Navigator - Release 1.8
Diagnostics & Troubleshooting
Access Bank II Loopbacks
Access Bank II Loopbacks
NOTE: All read remote and send remote commands require that the remote Access
Bank II is operational and connected to an Access Navigator drop DS1 using Carrier Access
FDL management protocol.
NOTE: Only one port of the Access Bank II can be looped up at a time. If a loopup command
is received for a second port, the first port will be looped down automatically before the second
port is looped up.
n Read Remote Loopback ... 15-36
n Send Remote Loopdown ... 15-36
n Send Remote RS232 Line Loopup ... 15-37
n Send Remote RS232 TSI Equipment Loopup ... 15-37
n Send Remote RS232 TSI Network Loopup ... 15-38
n Send Remote SDSL Payload Loopup ... 15-38
n Send Remote T1 Payload Loopup ... 15-39
n Send Remote T1 TSI Loopup ... 15-39
n Send Remote T1 Drop Line Loopup ... 15-40
n Send Remote T1 Drop Payload Loopup ... 15-40
n Send Remote V35 Line Loopup ... 15-41
n Send Remote T1 Drop Line Loopup ... 15-40
n Send Remote T1 Drop Payload Loopup ... 15-40
n Send Remote V35 Line Loopup ... 15-41
n
Send Remote V35 TSI Equipment Loopup ... 15-42
n Send Remote V35 TSI Network Loopup ... 15-42
Read Remote Loopback
Reads and displays the loopback status of the remote terminal on the specified DS1. Used to read status
of the following send remote commands.
Syntax: read remote loopback
Send Remote Loopdown
Disables the send remote loopup commands.
Syntax: send remote loopdown