Clear blocked call count, Clear peak call count, Clear permanent call count – Carrier Access Access Navigator User Manual
Page 370: Set crv idle, Clear permanent call count on
15-28
August 2003
Access Navigator - Release 1.8
Diagnostics & Troubleshooting
Clear Blocked Call Count
Clear Blocked Call Count
Sets the blocked call count to zero (see Status TMC on
).
Syntax:
clear blocked call count
Clear Peak Call Count
Sets the peak call count to zero (see Status TMC on
Syntax:
clear peak call count
Clear Permanent Call Count
Sets the permanent call count to zero (see Status TMC on
). After clearing the count, the
Access Navigator will recalculate the current number of permanent calls.
Syntax:
clear permanent call count
Set CRV Idle
Clears a permanent off-hook call state (see Status TMC on
) by setting it to the normal idle
state. After clearing the count, the Access Navigator will recalculate the current number of permanent
calls. A call can be active, idle, or permanent. You can check the current call state with the status
crv
command. An active call can not be set to idle.
Syntax:
set crv
Peak Calls
Maximum number of calls at one time. (To clear, see “Clear
Peak Call Count” on page 28.)
Switch Ports
Number of DS0 ports connected to the switch (excludes EOC
and TMC DS0s).
Percent Used
Percentage of switch ports in use, rounded to nearest whole
number.
Field
Description
value
Call Reference Value, 1 to 768, or a range of values such as 5-8.
Maximum range is 24 CRVs.
Item
Description