Carrier Access Access Navigator - Manual (Page 500)

18-44 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Logon Remote
Purpose: Starts a remote CLI management session with a Adit 600 TDM terminal connected to
a DS1 drop. During an RS-232 or Telnet CLI management session, the user enters the
logon
remote command at the Access Navigator prompt. The remote terminal will
then respond with a Adit 600 prompt for entering Adit 600 CLI commands. For
descriptions of Adit 600 CLI commands, refer to the Adit 600 TDM User Manual.
NOTE: To exit from a remote management session, see Exit Remote
Session (Ctrl+C) on page 18-34 .
Security: Level 2 (operator)
Syntax: logon remote <n>
Example: logon remote 12
The following example is typical response to the logon remote command:
Access Navigator> logon remote 3
Remote CLI session attached on ds1 3.
(use to end remote CLI session.)
-----------------------------------------------------------
CLI session with remote goes here.
Session ends when user presses .
Terminating remote 3 CLI session...
-----------------------------------------------------------
Remote CLI session on ds1 3 terminated.
Access Navigator>
Switch TermID:DS0 Switch terminal identifier, 1 to 28, and DS0 channel, 1 to 24.
(TermID is not same as DS1 number.)
Drop DS1:DS0 Drop DS1 number, 1 to 32, and DS0 channel, 1 to 24.
CRV Call Reference Value, 1 to 768
TMC Event Message describing the event.
Cause Numeric value assigned by switch to identify error type.
Field Description
n DS1 number, 1 to 32.
Item Description