Provision and connect isdn pri channels, Provision and connect isdn bri 3ds0 channels – Carrier Access Access Navigator User Manual
Page 210
9-16
August 2003
Access Navigator - Release 1.8
Provision DCS Service
Provision and Connect ISDN PRI Channels
Provision and Connect ISDN PRI Channels
Full and fractional ISDN PRI passthrough service is provisioned and connected in the same way as other
DS0 data channels (described on the following pages). For each ISDN PRI channel to be provisioned, the
operator must create crossconnections for the desired number of bearer channels (B1 up to B23) and the
signaling channel (D). All PRI channels must be set to the DS0 Type Data.
Provision and Connect ISDN BRI 3DS0 Channels
ISDN BRI service using 3DS0 transport mode is provisioned and connected in the same way as other DS0
data channels (described on the following pages), except that each ISDN BRI requires three DS0s. For each
ISDN BRI to be provisioned, the operator must create crossconnections for the two bearer channels (B1 and
B2) and the signaling channel (D). All BRI channels must be set to the DS0 Type Data.
To provision ISDN BRI 4:1 TDM transport mode using GR-303, see Provision ISDN BRI 4:1 TDM Service
to Subscribers on