Carrier Access Access Navigator - Manual (Page 169)

Access Navigator - Release 1.8 August 2003 6-65
Electrical Installation
Set Gateway Address
Set the Ethernet IP address and mask by typing the following line after the prompt, then press the Enter
or Return key.
set ethernet ip address
Example: set Ethernet address 192.168.118.65 255.255.255.0
To turn off Ethernet interface, enter
set ethernet ip address none
To display current settings, enter
show ip
Requirement: Access Navigator responds with correct IP address.
Set Gateway Address
NOTE: Gateway Address – A gateway is any device that passes packets from one
network to another network in their trip across the Internet. Gateway addresses have the
same format as IP addresses. If a gateway address is not used, you must enter none for
the gateway address.
Set the gateway IP address by typing the following line after the prompt, then press the Enter or Return
key.
set ip gateway
If the gateway address is not used, enter
set ip gateway none
To display current settings, enter
show ip
Requirement: Access Navigator responds with correct gateway IP address.
Exit Management Session
NOTE: You will remain logged into the Access Navigator until you use the exit
command.
When you are finished with the management session, you must log out and exit from the Access
Navigator by entering the following command:
exit