Carrier Access Access Navigator - Manual (Page 502)

18-46 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Message:
Alarms:
Current Accumulated
------- -----------
sys power off off
sys brownout off off
sys redun off off
sys reset off off
v35 rts off off
v35 llb off off
v35 v54 off off
t1 (T1#1) carrier off off
t1 (T1#1) csuloop off off
t1 (T1#1) unframed off off
t1 (T1#1) sync off off
t1 (T1#1) yellow off off
t1 (T1#1) bpv off off
t1 (T1#1) ses off off
t1 (T1#1) unavail off off
t1 (T1#1) fdlline off off
t1 (T1#1) fdlpay off off
t1drop (T1#2) carrier off off
t1drop (T1#2) csuloop off off
t1drop (T1#2) unframed off off
t1drop (T1#2) sync off off
t1drop (T1#2) yellow off off
t1drop (T1#2) bpv off off
t1drop (T1#2) ses off off
t1drop (T1#2) unavail off off
t1drop (T1#2) fdlline off off
t1drop (T1#2) fdlpay off off
Item Description
Current Indicates current alarm state
Accumulated Indicates if any alarms have occurred (accumulated) since the
last time the alarm status was read. This flag is cleared (set to
“off”) after reading.
off No alarms occurred
on One or more alarms occurred
sys power Hard reset or power-on detected
sys brownout Low input power (–48 VDC input) detected
sys redun Redundant T1 switch occurred
(This feature is not supported by the Access Navigator)
sys reset Soft reset detected