Carrier Access Access Navigator - Manual (Page 550)

18-94 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Figure 18-23. Remote V.35 TSI Equipment Loopup
Security: Level 2 (operator)
Syntax: send remote v35 tsi <equipment|network> loopup
Example: send remote 9 v35 tsi equipment loopup
Example: send remote 9 v35 tsi network loopup
Message: Loop command sent to remote.
Send Switch Provision Request
Purpose: This is a Level 1 command that allows a network manager to request ISDN CRV
provisioning information for newly configured ISDN CRVs. When RDT provisioning
is enabled at the switch, the switch will configure the D channel crossconnections. If
RDT provisioning is not enabled, the ISDN CRVs must be entered manually on both
the switch and the Access Navigator.
Security: Level 1 (manager)
Syntax: send switch provision request
Field Description
n DS1 number, 1 to 32.
equipment Loopup the equipment side
network Loopup the network side
V.35 DS1
Access
Navigator
CA FDL
Command
Access Bank II
V.35
TSI Equipment Loopup
T1 Interface
Time Slot
Interchange
Framer