Update software via xmodem (one controller), Procedure summary, Overview – Carrier Access Access Navigator User Manual
Page 451: Update software via xmodem (one controller) -17, Procedure summary -17 overview -17, Update software via xmodem (one controller) on, Pdate, Oftware, Modem, Ontroller
Access Navigator - Release 1.8
August 2003
17-17
Update Controller Card Software
Update Software via Xmodem (One Controller)
Update Software via Xmodem (One Controller)
Procedure Summary
n
n
n
Information and Materials Required
n
n
Overview
Xmodem Requirements
The Controller update software file must be located on a compact disk (CD), hard drive, or file
server accessible by the craft terminal or management computer through a file name or path name.
File transfers are accomplished using Xmodem protocol, which is supported by most terminal
emulation programs, such as Microsoft HyperTerminal. Using an RS-232 management session, the
operator sends a CLI “load xmodem” command to the Access Navigator. The operator then
instructs the terminal program to send the update file. Updating the active Controller will take about
30 minutes.