Carrier Access Access Navigator - Manual (Page 630)

18-174 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Secondary
Channel: DS1 #29 channel 24
Link Status: Up
Mode: Standby
Total POTS ISDN
----- ---- ----
Active Calls: 206 0 0
Permanent Calls: 0 0 0
Peak Calls: 233 0 0
Terminating Calls: 104 0 0
Originating Calls: 102 0 0
Blocked Calls: 0
Item Description
Primary Primary TMC channel
Secondary Primary TMC channel
Channel Location of TMC, by DS1 and DS0 number.
Link Status Up – indicates LAPD communications link with switch is
established and healthy.
Down – out of service.
None – no link defined.
Mode Active or Standby – One TMC is active and the other is in
standby. If the active TMC fails, the switch will command the
standby TMC to become active.
POTS Number of Plain Old Telephone Service calls
ISDN Number of Integrated Services Digital Network, Basic Rate
Interface calls.
Active Calls Number of currently active calls.
Permanent Calls Number of calls currently set in a permanent off-hook state. This
state will be cleared when an on-hook is observed for more than
400 milliseconds.
Peak Calls Maximum number of calls at one time.
Terminating Calls Number of calls terminating on subscriber drops at current time.
Originating Calls Number of calls originating from subscriber drops at current
time.
Blocked Calls Number of calls blocked by Access Navigator or switch. Switch
may also refuse call if line configuration is not correct. Blocking
can occur because:
• Switch side DS0s are not available for call request.
• Switch is not configured for call request from CRV.