Carrier Access Access Navigator - Manual (Page 606)

18-150 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Show Remote
Purpose: Displays the port settings for the remote Access Bank II at the far end of the DS1. Use
the set remote command to change port settings.
Security: Level 3 (monitor)
Syntax: show remote <n|all>
Example: show remote 9
Example: show remote 1-5
Example: show remote all
Message:
Settings for remote device Remote Device #11:
Remote Config: enabled
T1 Drop Port:
Line Coding: AMI
Framing: D4
Line Build Out: DSX-1 0-133 ft. (or 0 db)
PRM: AT&T
V.35 Port:
CTS: Always High
Rx Timing: Internal
Clock Inversion: None
Data Inversion: Normal
Speed: Nx64
DSU: On
RS232 Port:
Baud Rate: 9,600
Data Bits: 8
Parity: None
Stop Bits: 1
Description:
Field Description
n DS1 number, 1 to 32, or a range of numbers such as 2-8.
all Display all DS1 remote interfaces.
Item Description
Remote Config enabled (on), disabled (off)
T1 Drop Port:
Line Coding AMI, B8ZS
Framing D4 (SF), ESF