Carrier Access Access Navigator - Manual (Page 513)

Access Navigator - Release 1.8 August 2003 18-57
CLI Language Reference
CLI Command List
Reset All
CAUTION! T HE “ RESET ALL ” COMMAND WILL INTERRUPT SERVICE FOR ABOUT 30
SECONDS . DCS CROSSCONNECTS WILL BE RESTORED . GR-303 CROSSCONNECTS WILL
BE LOST .
Purpose: Produces a soft reset of both Controller cards. It is equivalent to a hard reset, in which
the Access Navigator is powered off and on again. The entire process takes about 30
seconds.
Security: Level 2 (operator)
Syntax: reset all
The reset all command has the following effects:
l Resets both Controller cards.
l Erases all RAM data, including the GR-303 crossconnects, status, event log,
time, and date.
l
Does not affect provisioning and other settings stored in flash memory.
l Upon restart, provisioning and other settings are restored.
l Upon restart, the clock starts at time 00:00:00 and date 01/01/1998.
l Upon restart, the status interval timer starts at zero seconds.
Reset DS1 Framer
CAUTION! T HE “ RESET DS1” COMMAND WILL MOMENTARILY DISRUPT SERVICE
WHILE THE DS1 FRAMER RESYNCHRONIZES .
Purpose: Enables the operator to reset one or more DS1 framers. The command resets the DS1
receiver and may be used to test Loss of Frame recovery.
Security: Level 2 (operator)
Syntax: reset ds1
Example: reset ds1 9
Example: reset ds1 5-8
Field Description
n DS1 number, 1 to 32, or a range of numbers such as 2-8.