Carrier Access Access Navigator - Manual (Page 257)

Access Navigator - Release 1.8 August 2003 11-9
Provision Remote Access Bank II
Remote Access Bank II Provisioning Quick Guide
Remote Access Bank II Provisioning Quick Guide
NOTE: Do not locally provision the Access Bank II if you are remotely provisioning it
through the Access Navigator. Local changes made to the Access Bank II will not be
recorded in the Access Navigator data base. Consequently, any local changes will be
overwritten when the Access Navigator downloads configuration settings.
Related Commands Access Bank II
Provisioning Items
set remote config off Temporarily disable configuration
downloading to remote Access Bank
II.
set ds1 type drop
set ds1 framing esf
set ds1 linecode b8zs
set ds1 remote mgmt cafdl
set ds1 lbo
set ds1 loopdetect off
set ds1 id <"name">
set remote id <"name"> Provision DS1 service to remote,
including remote management
interface.
set ds0 type
set ds0 signaling
set ds0 crv
set ds0 up Provision DS0 service to remote.
connect
disconnect Provision DCS crossconnects to
remote.
read remote connections
read remote rs232
read remote t1
read remote t1drop
read remote v35 Read remote DS0 connections and
interface settings.
Note: SDSL interface port has no
settings to read.
add interface <"name"> Create fractional interface and assign
DS0s to be used.
set remote rs232
set remote t1drop
set remote v35 Configure remote interface port to
meet customer requirements.
connect remote <"name">
disconnect remote <"name"> Connect fractional interface to remote
interface port.
set remote config on
set ds1 up Download configuration and
turn up service.