Carrier Access Access Navigator - Manual (Page 382)

15-40 August 2003 Access Navigator - Release 1.8
Diagnostics & Troubleshooting
Send Remote T1 Drop Line Loopup
Send Remote T1 Drop Line Loopup
This command makes the remote Access Bank II perform a line loopback on the T1 Drop output. This
takes the received T1 Drop DS1 signal, loops it in the framer, and sends it back to the T1 Drop output.
See Figure 15-18.
Syntax: send remote t1drop line loopup
Figure 15-17. Remote T1 TSI Loopup
Send Remote T1 Drop Payload Loopup
This command makes the remote Access Bank II perform a payload loopback on the T1 Drop interface.
This takes the received T1 Drop DS0s, loops them in the framer, and sends them back to the T1 Drop
output. See Figure 15-19.
Syntax: send remote t1drop payload loopup
Figure 15-18. Remote T1drop Line Loopup
DS1
Access
Navigator
Framer
CA FDL
Command
Access Bank II
T1
TSI Loopup
T1
Time Slot
Interchange
DS1
Access
Navigator
Framer
CA FDL
Command
Access Bank II
T1 Drop
Line Loopup
T1 Framer T1 Drop DS1
Time Slot
Interchange