Disconnect remote, Exit, Exit remote session (ctrl+c) – Carrier Access Access Navigator User Manual
Page 490: Disconnect remote -34, Exit -34, Exit remote session (ctrl+c) -34, Disconnect remote on
18-34
August 2003
Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Disconnect Remote
Purpose:
Removes the DS0 connections established by the connect remote command.
Security:
Level 2 (operator)
Syntax:
disconnect remote <"name">
Example:
disconnect remote "AcmeV35"
Exit
Purpose:
Ends management session and logs out the user. When finished with a management
session, it is important to log out from the Access Navigator by typing the exit
command. Logging out will maintain network security, ensuring that the next user must
log in with a valid user name and password.
Security:
Level 3 (monitor)
Syntax:
exit
Exit Remote Session (Ctrl+C)
Purpose:
To end a remote CLI management session to an Adit 600 terminal, press the Ctrl+C
keys to cancel the connection to the remote Adit 600 terminal. The Access Navigator
prompt will then appear. To start a remote session, seeLogon Remote on
NOTE:
To enter the Ctrl+C command, hold down the Control (Ctrl) key on
the keyboard and press the C key. Some terminal programs must be configured
to pass through control codes, rather than intercepting the control codes as
commands to the terminal program.
Field
Description
name
The user defined name for the fractional interface. The name
must be enclosed in quotes.