Carrier Access Access Navigator - Manual (Page 194)

8-12 August 2003 Access Navigator - Release 1.8
Provision Access Navigator
Set SNMP Properties
Example: set snmp setcom "Public"
8. Set SNMP Trap-Community string with the following command:
set snmp trapcom <"setting">
Example: set snmp trapcom "Public"
NOTE: SNMP trap alarm messages can be sent to three different host IP addresses.
Repeat the following command to set the IP address of each recipient.
9. Set up to three SNMP NMS (network management system) trap recipients by entering their IP
addresses with the following command:
set snmp nms <1|2|3>
Example: set snmp nms 1 192.168.118.65