Provision drop ds0s to remote adit, Provision drop ds0s to remote adit -19 – Carrier Access Access Navigator User Manual
Page 315
Access Navigator - Release 1.8
August 2003
13-19
Provision Remote Adit 600 via IP DS0
Provision Drop DS0s to Remote Adit
Provision Drop DS0s to Remote Adit
NOTE:
Commands such as ds0
and DS0 channel number or channel range. The DS1 and DS0 numbers are entered with
a colon separating the numbers. For example, the channel list for DS1 #4 and DS0 channel
#8 would be entered as ds0 4:8. The channel list may also contain a range of DS0
channels. For example, DS1 #6 and DS0 channels #1 through #12 would be entered as
ds0 6:1-12
. A colon follows the DS1 number, and the beginning and ending DS0
channels are separated by a hyphen.
NOTE:
When connected to a Nortel DMS switch, each Access Navigator can support
up to 384 P-Phone channels from up to 14 Adit 600 terminals.
1. Show current DS0 settings with the following command:
show ds0
Example:
show ds0 13:1-4
The show command will produce a status message for each DS1 specified. For example, the mes-
sage for DS1 number 13, DS0 channels 1 to 4 would look similar to the following:
Settings for DS1 13, Channel 1:
Type: GR303
Signaling: LOOP
START
Up/Down: UP
CRV:
35
PPHONE:
Enabled
ISDN:
None
Settings for DS1 13, Channel 2:
Type: GR303
Signaling: DID
Up/Down: UP
PPHONE:
Enabled
CRV:
36
ISDN:
None
Settings for DS1 13, Channel 3:
Type:
DATA
Up/Down: DOWN
CRV:
No CRV assigned
PPHONE:
Enabled
ISDN:
None
Settings for DS1 13, Channel 4:
Type:
GR303
Up/Down: UP
CRV:
38
PPHONE:
Enabled
ISDN:
None