Carrier Access Access Navigator - Manual (Page 200)

9-6 August 2003 Access Navigator - Release 1.8
Provision DCS Service
DCS Provisioning Quick Guide
DCS Provisioning Quick Guide
CLI Commands Descriptions
status equipment Verify equipment configuration.
show ds1 <n|all>
status ds1
status ds0
Verify service status.
set ds1 down
set ds0 down
set ds0 type <voice|data>
Set unused circuits out of service
(down). If the DS1 is not terminated,
set the DS0 type of all channels to
data. If the DS1 is terminated, set the
DS0 type of any unused channels to
match the DS0 type (voice or data)
configured on the device at the other
end of the DS1.
set clock1 <bits|ds1 n|internal> Primary system clock source.
set clock2 <bits|ds1 n|internal> Secondary system clock source.
set ds1 type <groom|drop> DS1 type.
set ds1 framing <d4|esf> DS1 framing.
set ds1 linecode <ami|b8zs> DS1 line code.
set ds1 id <"id"> DS1 identifier.
set ds1 clock <normal|loop> DS1 clock source.
set ds1 lbo <setting> DS1 line buildout.
set ds1 loopdetect <on|off> Usually off for drop DS1s.
show connect Verify DS0 crossconnections.
disconnect Remove old DS0 connections.
set ds0 type <voice|data> DS0 type (use data type for ISDN PRI
passthrough).
set ds0 signal <ls|gs|em> DS0 signaling (voice type only).
connect Add DS0 crossconnections.
set ds0 up Set DS0s in service.
set ds1 up Set DS1s in service.