Verify equipment status, Verify equipment status -6, Warning – Carrier Access Access Navigator User Manual
Page 440: Caution
17-6
August 2003
Access Navigator - Release 1.8
Update Controller Card Software
Verify Equipment Status
Verify Equipment Status
1. If you are not currently logged into the Access Navigator, start an RS-232 or Telnet management
session.
2. Verify current Controller software version with the following command:
status equipment all
A message similar to the following will appear, showing the Controller cards installed and the
software version.
Equipment Status Version
--------- ------ -------
Controller A Active 01.77 GR-303 Option
Controller B Standby 01.77 GR-303 Option
DS1 Card 1 Installed 1
DS1 Card 2 Installed 1
DS1 Card 3 Installed 1
DS1 Card 4 Installed 1
DS1 Card 5 Installed 1
DS1 Card 6 Installed 1
DS1 Card 7 Card not installed 1
DS1 Card 8 Card not installed 1
Active Standby
------ -------
SW Build Number 17701 17701
Boot Code Revision 01.09 01.07
FPGA Code Revision 1.06 1.06
Requirement:
One Controller is in “Standby”.
WARNING!
D
O
NOT
CONTINUE
THIS
PROCEDURE
IF
THE
C
ONTROLLER
V
ERSION
IS
01.70
UP
TO
AND
INCLUDING
01.80
OR
IF
THE
B
OOT
C
ODE
R
EVISION
IS
01.07
OR
01.08. U
SE
THE
UPGRADE
PROCEDURE
IN
P
RODUCT
T
ECHNICAL
N
OTE
PTN-03-004,
AVAILABLE
BY
CALLING
C
ARRIER
A
CCESS
C
USTOMER
S
UPPORT
AT
(800) 495-5455.
CAUTION!
D
O
NOT
CONTINUE
THIS
PROCEDURE
IF
ONE
C
ONTROLLER
IS
NOT
IN
STANDBY
. T
HIS
INDICATES
THE
SYSTEM
IS
NOT
PROTECTED
BECAUSE
THE
SECOND
C
ONTROLLER
IS
EITHER
NOT
OPERATIONAL
(
STATUS
UNKNOWN
)
OR
IS
NOT
INSTALLED
.
I
F
THE
C
ONTROLLER
IS
NOT
OPERATIONAL
,
REPLACE
THE
FAILED
C
ONTOLLER
BEFORE
UPDATING
SOFTWARE
(
SEE
I
F
THERE
IS
ONLY
ONE
C
ONTROLLER
CARD
IN
THE
SYSTEM
,
SEE
.