Carrier Access Access Navigator - Manual (Page 246)

10-32 August 2003 Access Navigator - Release 1.8
Provision GR-303 Service
Assign Call Reference Values (CRVs)
Assign Call Reference Values (CRVs)
CAUTION! S ERVICE DISRUPTIONS CAN OCCUR IF YOU ASSIGN A CRV THAT IS
ALREADY IN USE BY ANOTHER SUBSCRIBER . A LWAYS VERIFY CRV S BEFORE MAKING
CHANGES . D O NOT USE THESE STEPS TO CHANGE ISDN BRI CRV S .
NOTE: The IDT switch system will need to know the Call Reference Value (CRV) for
each GR-303 DS0 voice termination. The switch uses the CRV to set up crossconnects.
The CRV for each DS0 is programmable. Factory default CRVs are sequentially numbered
from 1 to 768 (as shown in Figure 10-5), starting with the first DS0 channel on DS1 #1 and
continuing to the last DS0 channel on DS1 #32. If required, the user can assign different
CRV numbers. The only requirement is that the CRVs must be different for all assigned
GR-303 voice terminations. ISDN BRI connections use the same CRV for the B1, B2, and
D channel.
NOTE: A CRV with an active call can not be moved or reassigned.
NOTE: To avoid duplication when setting CRV numbers, if another channel has the
same CRV number, it will be set to CRV #0 (not assigned).
1. Show current CRV settings with the following command:
show crv
Example: show crv 1-8
The show command will display the range of CRVs requested (up to 24), along with the DS1 and
DS0 channel to which they are currently assigned. For example, the message for showing CRV
numbers 1 to 8 would look similar to the following:
CRV Interface Status
--- --------- ------
1 DS1 #1 channel 1 In Service
2 DS1 #1 channel 2 In Service
3 DS1 #1 channel 3 In Service
4 DS1 #1 channel 4 In Service
5 DS1 #2 channel 25 In Service
6 DS1 #2 channel 26 In Service
7 DS1 #2 channel 27 In Service
8 DS1 #2 channel 28 Out of Service