Connect dsx-1 cables to interface or patch panel, Warning – Carrier Access Access Navigator User Manual
Page 118
6-14
August 2003
Access Navigator - Release 1.8
Electrical Installation
Connect DSX-1 Cables to Interface or Patch Panel
Connect DSX-1 Cables to Interface or Patch Panel
WARNING!
NEBS R
EQUIREMENT
. D
O
NOT
CONNECT
THIS
EQUIPMENT
DIRECTLY
TO
METALLIC
TIP
-
AND
-
RING
OUTSIDE
PLANT
CONDUCTORS
. T
HIS
EQUIPMENT
CAN
ONLY
BE
USED
FOR
INTRA
-
BUILDING
(
INSIDE
PLANT
)
INSTALLATION
IN
A
CENTRAL
OFFICE
OR
CUSTOMER
PREMISES
.
NOTE:
Access Navigator can be equipped with up to 32 DS1 interfaces, in steps of 4
DS1s per Quad Framer (QF) circuit card installed. DS1 receive and transmit pairs are
numbered sequentially from 1 to 32 in Table 2-1.
NOTE:
ABAM shielded cable is recommended for extending DSX-1 connections.
Connect DSX-1 receive and transmit cables to DSX-1 interface or patch panel.
•
Follow standard practices for DS1 signal connections.
•
For DSX-1 cable pin connections and flying wire colors, refer to Table 2-1.