Carrier Access Access Navigator - Manual (Page 295)

Access Navigator - Release 1.8 August 2003 12-17
Provision Remote Adit 600 via FDL
Provision Remote Adit 600
Provision Remote Adit 600
1. Start remote management session with Adit 600 terminal, where is the number of the Access
Navigator drop DS1 going to the terminal.
logon remote
Example: logon remote 10
2. When Adit 600 prompt appears, provision terminal using Adit 600 CLI commands (refer to Adit
600 User Manual.
3. When finished provisioning Adit 600 terminal, enter Ctrl+C to cancel the connection to the
remote terminal. The Access Navigator prompt will then appear.
4. Exit management session when finished.
exit
Test DS1 and DS0 Circuits
NOTE: The Access Navigator can be pre-provisioned so that it will be ready to provide
services when facilities become available. Therefore, it may be necessary to skip over the
circuit testing steps in this procedure.
NOTE: The Access Navigator supports the following T1.403 loop tests:
• Responds to ESF bit patterned loop requests (when loopdetect is on)
• Generates ESF bit patterned loop requests
• Generates SF CSU inband loopcodes
NOTE: The Access Navigator provides line and payload loopback commands for
troubleshooting line problems. See Diagnostics & Troubleshooting on page 15-1 .
1. Follow standard practices to test subscriber drop DS1 circuits.
2. Follow standard practices to test DS0 connections, analog channels, and remote interfaces.