Set ds0 p-phone, Set ds0 p-phone -101 – Carrier Access Access Navigator User Manual
Page 558
18-102
August 2003
Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Set DS0 P-Phone
Purpose:
Assigns DS0 channels for P-Phone service. The set ds0 pphone none command is
used to remove the P-Phone assignment from a DS0.
NOTE:
This command only applies to P-Phone (EBS) channels from remote
Adit 600 terminals using Carrier Access IP (CAIP) remote management (see
Set DS1 Remote Device Mgmt on
.) When connected to a Nortel
DMS switch, each Access Navigator can support up to 384 P-Phone channels
from up to 14 remote Adit 600 terminals.
Security:
Level 2 (operator)
Syntax:
set ds0
Syntax:
set ds0
Example:
set ds0 10:1 pphone
Example:
set ds0 10:2 pphone none
Example:
set ds0 12:9-16 pphone
Field
Description
n
DS1 number, 1 to 32.
ch
DS0 number, 1 to 24, or a range of numbers such as 5-8.
pphone
Set DS0 to carry P-Phone service.
none
Removes P-Phone assignment.