Carrier Access Access Navigator - Manual (Page 146)

6-42 August 2003 Access Navigator - Release 1.8
Electrical Installation
Verify RS-232 Management Connection
Verify RS-232 Management Connection
NOTE: Security – No names or passwords are required for new installation and initial
turn up. The Access Navigator will accept any user, until password security is turned on.
NOTE:
Command Line Interface – The Access Navigator operating system provides a
Command Line Interface (CLI), which uses simple text based commands and messages.
See Command Line Interface Conventions on
page 7-3 for a short description of the
conventions used in this manual to represent management commands, settings, and
messages. For additional information, see CLI Language Reference on
page 18-1 .
1. Turn on power to computer, craft terminal, and optional modem (if used).
2. Configure computer terminal emulation software, or craft terminal, as follows:
• Terminal emulation: ANSI, ASCII, VT100
• Flow control: None
• Send mode: echo characters locally
• Baud rate: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
NOTE:
In the following step, it is only important that the Access Navigator respond with
a message. A typical message includes the name of the unit, the time and date, and a
prompt.
3. Initiate RS-232 management session by pressing keyboard Enter or Return key.
Carrier Access Corporation Access Navigator
08:30:45 01/30/1999
Access Navigator>
Requirement: Access Navigator message appears on computer or craft terminal display.
NOTE:
If there is no response from the Access Navigator, refer to Diagnostics &
Troubleshooting on page 15-1 .