Carrier Access Access Navigator User Manual
Page 616
18-160
August 2003
Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Description:
Item
Description
Receive
Traffic – normal operation.
(The CLI also shows alarm conditions.)
Transmit
Traffic – normal operation.
(The CLI also shows alarm conditions.)
Loop
None – normal operation.Line – line loopback.
Payload – payload loopback.
State
In use as DROP – Subscriber “drop” DS1.
In use as GROOM – DCS “groom” DS1.
In Service – GR-303 “switch” DS1.
User set Out of Service – User set DS1 down.
Card Not Installed – Empty card slot
(The CLI also displays alarm messages such as RAI.)
FDL Type
None – No detection or response (only option for switch DS1s).
SLC96 – Required for Shelf A of SLC-96/TR-08 group.
T1403 – Detects and responds to ANSI T1.403 codes.
(See Set DS1 FDL on
.)
Remote Device
Mgmt Type
None – no management
CA FDL – Used to provision remote Access Bank II or
establish pass-through management session to Adit 600.
CA IP <ipaddress> – Used for IP DS0 management of
remote Adit 600.
CA DS1 <n> – Used for IP DS0 management of remote
Adit 600.
(See Set DS1 Remote Device Mgmt on
Remote Device Mgmt
Status
Up or Down – Shown only if Remote Device Mgmt Type is CA
IP or CA FDL.