Loading by xmodem through console port, Introduction to xmodem, Loading boot rom – H3C Technologies H3C S3600 Series Switches User Manual

Page 998

1-3

Enter the correct Boot ROM password (no password is set by default). The system enters the BOOT

Menu:

BOOT MENU

1. Download application file to flash

2. Select application file to boot

3. Display all files in flash

4. Delete file from flash

5. Modify bootrom password

6. Enter bootrom upgrade menu

7. Skip current configuration file

8. Set bootrom password recovery

9. Set switch startup mode

0. Reboot

Enter your choice(0-9):

Loading by XModem through Console Port

Introduction to XModem

XModem protocol is a file transfer protocol that is widely used due to its simplicity and high stability. The

XModem protocol transfers files through Console port. It supports two types of data packets (128 bytes

and 1 KB), two check methods (checksum and CRC), and multiple attempts of error packet

retransmission (generally the maximum number of retransmission attempts is ten).

The XModem transmission procedure is completed by a receiving program and a sending program. The

receiving program sends negotiation characters to negotiate a packet checking method. After the

negotiation, the sending program starts to transmit data packets. When receiving a complete packet,

the receiving program checks the packet using the agreed method. If the check succeeds, the receiving

program sends acknowledgement characters and the sending program proceeds to send another

packet. If the check fails, the receiving program sends negative acknowledgement characters and the

sending program retransmits the packet.

Loading Boot ROM

Follow these steps to load the Boot ROM:

Step 1: At the prompt "Enter your choice(0-9):" in the BOOT Menu, press <6> or , and then

press to enter the Boot ROM update menu shown below:

Bootrom update menu:

1. Set TFTP protocol parameter

2. Set FTP protocol parameter

3. Set XMODEM protocol parameter

0. Return to boot menu

Enter your choice(0-3):

Step 2: Press 3 in the above menu to download the Boot ROM using XModem. The system displays the

following setting menu for download baudrate:

This manual is related to the following products: