H3C Technologies H3C S3600 Series Switches - Manual (Page 172)

1-12
To do … Use the command … Remarks
Set the port state change
delay
link-delay delay-time
Required
No delay is introduced by default.
The delay configured in this way does not take effect for ports in DLDP down state. For information
about the DLDP down state, refer to DLDP.
Displaying and Maintaining Basic Port Configuration
To do... Use the command... Remarks
Display port configuration
information display interface [ interface-type |
interface-type interface-number ]
Display the enable/disable
status of port loopback
detection
display loopback-detection
Display brief information about
port configuration
display brief interface [ interface-type
[ interface-number ] ] [ | { begin | include |
exclude } regular-expression ]
Display port information about
a specified unit
display unit unit-id interface
Display the storm control
configurations.
display storm-constrain [ interface
interface-type interface-number ] [ | { begin
| exclude | include } regular-expression ]
Display the statistics on the
packets dropped on a port or all
ports display packet-drop { interface
[ interface-type interface-number ] |
summary }
Display the information about
the port with the link-delay
command configured
display link-delay
Available in any
view
Clear the statistics on packets
dropped on a port or all ports reset packet-drop interface
[ interface-type interface-number ] Available in user
view
Clear port statistics
reset counters interface [ interface-type |
interface-type interface-number ]
Available in user
view
After 802.1x is
enabled on a port,
clearing the
statistics on the port
will not work.
Ethernet Port Configuration Example
Network requirements
z Switch A and Switch B are connected to each other through two trunk port (Ethernet 1/0/1).