H3C Technologies H3C S3600 Series Switches - Manual (Page 821)

1-17
Configuring the enhanced cluster features
Complete the following tasks to configure the enhanced cluster feature:
Task Remarks
Configuring cluster topology management function Required
Configuring cluster device blacklist Required
Configuring cluster topology management function
1) Configuration prerequisites
Before configuring the cluster topology management function, make sure that:
z The basic cluster configuration is completed.
z Devices in the cluster work normally.
2) Configuration procedure
Follow these steps to configure cluster topology management function on a management device:
To do… Use the command… Remarks
Enter system view system-view —
Enter cluster view cluster —
Check the current topology and
save it as the standard
topology. topology accept { all [ save-to local-flash ] |
mac-address mac-address | member-id
member-id | administrator }
Required
Save the standard topology to
the Flash memory of the
administrative device
topology save-to local-flash Required
Restore the standard topology
from the Flash memory of the
administrative device
topology restore-from local-flash Optional
Display the detailed information
about a single device display ntdp single-device mac-address
mac-address
Display the topology of the
current cluster
display cluster current-topology
[ mac-address mac-address1
[ to-mac-address mac-address2 ] |
member-id member-id1 [ to-member-id
member-id2 ] ]
Display the information about
the base topology of the cluster
display cluster base-topology
[ mac-address mac-address | member
member-id ]
Display the information about
all the devices in the base
cluster topology
display cluster base-members
Optional
These
commands can
be executed in
any view.