H3C Technologies H3C S3600 Series Switches - Manual (Page 96)

1-2
z When saving the current configuration, you can specify the file to be a main or backup or normal
configuration file.
z When removing a configuration file from a switch, you can specify to remove the main or backup
configuration file. Or, if it is a file having both main and backup attribute, you can specify to erase
the main or backup attribute of the file.
z When setting the configuration file for next startup, you can specify to use the main or backup
configuration file.
Startup with the configuration file
When booting, the system chooses the configuration files following the rules below:
1) If the main configuration file exists, the switch initializes with this configuration.
2) If the main configuration file does not exist but the backup configuration file exists, the switch
initializes with the backup configuration.
3) If neither the main nor the backup configuration file exists, but the default configuration file
config.def exists, the switch initializes with the default configuration file; if the default configuration
file does not exist, the switch starts up without loading the configuration file.
At present, only a PoE-supported switch is shipped with a default configuration file.
Configuration Task List
Complete these tasks to configure configuration file management:
Task Remarks
Saving the Current Configuration Optional
Erasing the Startup Configuration File Optional
Specifying a Configuration File for Next Startup Optional
Saving the Current Configuration
You can modify the configuration on your switch at the command line interface (CLI). To use the
modified configuration for your subsequent startups, you must save it (using the save command) as a
configuration file.
Use the following command to save current configuration:
To do… Use the command… Remarks
Save current configuration
save [ cfgfile | [ safely ]
[ backup | main ] ]
Required
Available in any view