H3C Technologies H3C S3600 Series Switches - Manual (Page 65)

3-9
To do… Use the command… Remarks
Set the maximum number of
lines the screen can contain
screen-length screen-length
Optional
By default, the screen can contain
up to 24 lines.
You can use the screen-length 0
command to disable the function to
display information in pages.
Set history command buffer
size history-command max-size
value
Optional
The default history command buffer
size is 10. That is, a history
command buffer can store up to 10
commands by default.
Set the timeout time for the
user interface idle-timeout minutes
[ seconds ]
Optional
The default timeout time of a user
interface is 10 minutes.
With the timeout time being 10
minutes, the connection to a user
interface is terminated if no
operation is performed in the user
interface within 10 minutes.
You can use the idle-timeout 0
command to disable the timeout
function.
Note that if you configure to authenticate the users in the scheme mode, the command level available to
the users logging in to the switch depends on the user privilege level level command and the
service-type { ftp | lan-access | { ssh | telnet | terminal }* [ level level ] } command, as listed in Table
3-4 .
Table 3-4 Determine the command level when users logging in to switches are authenticated in the
scheme mode
Scenario
Authentication
mode
User type Command
Command
level
The user privilege level level
command is not executed, and the
service-type command does not specify
the available command level.
Level 0
The user privilege level level
command is not executed, and the
service-type command specifies the
available command level.
Determined by
the service-type
command
The user privilege level level
command is executed, and the
service-type command does not specify
the available command level.
Level 0
authentication-m
ode scheme
[ command-auth
orization ]
VTY users that
are
AAA&RADIUS
authenticated or
locally
authenticated
The user privilege level level
command is executed, and the
service-type command specifies the
available command level.
Determined by
the service-type
command