H3C Technologies H3C S3600 Series Switches - Manual (Page 754)

1-24
To do… Use the command… Remarks
Configure traffic accounting traffic-statistic inbound acl-rule
Required
By default, traffic accounting
is disabled.
Clear the traffic statistics
reset traffic-statistic inbound
acl-rule
Required
Configuration example
z Ethernet 1/0/1 is connected to the 10.1.1.0/24 network segment.
z Perform traffic accounting on the packets sourced from the 10.1.1.0/24 network segment.
z Clear the traffic statistics.
Configuration procedure:
system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] traffic-statistic inbound ip-group 2000
[Sysname-Ethernet1/0/1] reset traffic-statistic inbound ip-group 2000
Enabling the Burst Function
Refer to section Burst for information about the burst function.
Configuration prerequisites
You have determined that the burst function is required.
Configuration procedure
Follow these steps to enable the burst function:
To do… Use the command… Remarks
Enter system view system-view —
Enable the burst function burst-mode enable
Required
By default, the burst function is
disabled.
With the IRF function enabled, do not enable the burst function. Otherwise, packets may be forwarded
improperly. Refer to the IRF Fabric part for the detailed information about IRF.
Configuring Traffic Mirroring
Refer to section Traffic mirroring for information about traffic mirroring.