H3C Technologies H3C S3600 Series Switches - Manual (Page 325)

3-10
To do... Use the command... Remarks
Set RIP-2 packet
authentication
mode
rip authentication-mode
{ simple password | md5
{ rfc2082 key-string key-id |
rfc2453 key-string } }
Required
If you specify to use MD5 authentication, you
must specify one of the following MD5
authentication types:
z rfc2453 (this type supports the packet format
defined in RFC 2453)
z rfc2082 (this type supports the packet format
defined in RFC 2082)
Configuring RIP to unicast RIP packets
Follow these steps to configure RIP to unicast RIP packets:
To do... Use the command... Remarks
Enter system view system-view —
Enter RIP view rip —
Configure RIP to
unicast RIP packets
peer ip-address
Required
When RIP runs on the link that does not support
broadcast or multicast, you must configure RIP to
unicast RIP packets.
Displaying and Maintaining RIP Configuration
To do... Use the command... Remarks
Display the current RIP running status and
configuration information
display rip
Display RIP interface information display rip interface
Display RIP routing information display rip routing
Available in any view
Reset the system configuration related to RIP reset Available in RIP view
RIP Configuration Example
Network requirements
A small-sized company requires that any two nodes in its small office network communicate with each
other, and that the network devices automatically adapt themselves to any topology change so as to
reduce the work of manual maintenance.
In this case, RIP can implement communication between any two nodes.
Network diagram
According to the network requirements, the network topology is designed as shown in Figure 3-1 .