H3C Technologies H3C S3600 Series Switches - Manual (Page 323)

3-8
To do... Use the command... Remarks
Configure a default cost for
an incoming route
default cost value
Optional
1 by default
Configure RIP to
redistribute routes from
another protocol
import-route protocol
[ process-id ] [ cost value |
route-policy
route-policy-name ]*
Required
By default, RIP does not redistribute
any route from other protocols.
RIP Network Adjustment and Optimization
In some special network environments, some RIP features need to be configured and RIP network
performance needs to be adjusted and optimized. By performing the configuration mentioned in this
section, the following can be implemented:
z Changing the convergence speed of RIP network by adjusting RIP timers;
z Avoiding routing loops by configuring split horizon;
z Packet validation in network environments with high security requirements, and
z Configuring RIP to unicast RIP messages on interfaces with special requirements.
Configuration Prerequisites
Before adjusting RIP, perform the following tasks:
z Configuring the network layer addresses of interfaces so that adjacent nodes are reachable to
each other at the network layer
z Configuring basic RIP functions
Configuration Tasks
Configuring RIP timers
Follow these steps to configure RIP timers:
To do... Use the command... Remarks
Enter system view system-view —
Enter RIP view rip —
Set the RIP timers
timers { update
update-timer | timeout
timeout-timer } * Required
By default, the Update timer is 30 seconds
and the Timeout timer 180 seconds.
When configuring the values of RIP timers, you should take network performance into consideration
and perform consistent configuration on all routers running RIP to avoid unnecessary network traffic
and network route oscillation.