H3C Technologies H3C S3600 Series Switches - Manual (Page 461)

6-12
To do... Use the command... Remarks
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the current port as
a static member port for a
multicast group in a VLAN
multicast static-group
group-address vlan vlan-id
Required
By default, no port is configured as
a static multicast group member
port.
In VLAN interface view
Follow these steps to configure a static multicast group member port in VLAN interface view:
To do... Use the command... Remarks
Enter system view system-view —
Enter VLAN interface view
interface vlan-interface
interface-number
—
Configure specified port(s) as
static member port(s) of a
multicast group in the VLAN multicast static-group
group-address interface
interface-list
Required
By default, no port is configured
as a static multicast group
member port.
z You can configure up to 200 static member ports on an S3600 series switch.
z If a port has been configured as an IRF fabric port or a reflect port, it cannot be configured as a
static member port.
Configuring a Static Router Port
In a network where the topology is unlikely to change, you can configure a port on the switch as a static
router port, so that the switch has a static connection to a multicast router and receives IGMP messages
from that router.
In Ethernet port view
Follow these steps to configure a static router port in Ethernet port view:
To do... Use the command... Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the current port as a
static router port multicast static-router-port
vlan vlan-id
Required
By default, no static router port
is configured.