H3C Technologies H3C S3600 Series Switches - Manual (Page 826)

1-22
z Perform the above operations on the management device of the cluster.
z Creating a public local user is equal to executing these configurations on both the management
device and the member devices (refer to the AAA Operation part in this manual), and these
configurations will be saved to the configuration files of the management device and the member
devices.
z The public local user configurations cannot be synchronized to the devices that are on the cluster
blacklist.
z If a member device leaves the cluster, the public local user configurations will not be removed.
Displaying and Maintaining Cluster Configuration
To do… Use the command… Remarks
Display all NDP configuration and running
information (including the interval to send
NDP packets, the holdtime, and all
neighbors discovered)
display ndp
Display NDP configuration and running
information on specified ports (including
the neighbors discovered by NDP on the
ports)
display ndp interface port-list
Display global NTDP information display ntdp
Display device information collected by
NTDP
display ntdp device-list [ verbose ]
Display status and statistics information
about the cluster
display cluster
Display information about the candidate
devices of the cluster display cluster candidates
[ mac-address H-H-H | verbose ]
Display information about the member
devices of the cluster display cluster members
[ member-number | verbose ]
Available in
any view.
Clear the statistics on NDP ports
reset ndp statistics [ interface
port-list ] Available in
user view.
When you display the cluster topology information, the devices attached to the switch that is listed in the
backlist will not be displayed.