H3C Technologies H3C S3600 Series Switches - Manual (Page 50)

2-8
# Specify not to authenticate users logging in through the console port.
[Sysname-ui-aux0] authentication-mode none
# Specify commands of level 2 are available to users logging in to the AUX user interface.
[Sysname-ui-aux0] user privilege level 2
# Set the baud rate of the console port to 19,200 bps.
[Sysname-ui-aux0] speed 19200
# Set the maximum number of lines the screen can contain to 30.
[Sysname-ui-aux0] screen-length 30
# Set the maximum number of commands the history command buffer can store to 20.
[Sysname-ui-aux0] history-command max-size 20
# Set the timeout time of the AUX user interface to 6 minutes.
[Sysname-ui-aux0] idle-timeout 6
After the above configuration, you need to modify the configuration of the terminal emulation utility
running on the PC accordingly in the dialog box shown in Figure 2-4 to log in to the switch successfully.
Console Port Login Configuration with Authentication Mode Being
Password
Configuration Procedure
Follow these steps to configure console port login with the authentication mode being password:
To do… Use the command… Remarks
Enter system view system-view —
Enter AUX user interface
view
user-interface aux 0 —
Configure to authenticate
users using the local
password
authentication-mode
password
Required
By default, users logging in to a switch
through the console port are not
authenticated; while those logging in
through Modems or Telnet are
authenticated.
Set the local password
set authentication
password { cipher |
simple } password
Required