H3C Technologies H3C S3600 Series Switches - Manual (Page 815)

1-11
To do… Use the command… Remarks
Enter system view system-view —
Configure the range to collect
topology information
ntdp hop hop-value
Optional
By default, the system collects
topology information from the
devices within three hops.
Configure the device forward
delay of topology collection
requests
ntdp timer hop-delay time
Optional
By default, the device forward
delay is 200 ms.
Configure the port forward
delay of topology collection
requests
ntdp timer port-delay time
Optional
By default, the port forward
delay is 20 ms.
Configure the interval to collect
topology information
periodically
ntdp timer interval-in-minutes
Optional
By default, the topology
collection interval is one
minute.
Quit system view quit —
Launch topology information
collection manually
ntdp explore Optional
Enabling the cluster function
Follow these steps to enable the cluster function:
To do… Use the command… Remarks
Enter system view system-view —
Enable the cluster function
globally
cluster enable
Required
By default, the cluster function
is enabled.
Configuring cluster parameters
The establishment of a cluster and the related configuration can be accomplished in manual mode or
automatic mode, as described below.
1) Establishing a cluster and configuring cluster parameters in manual mode
Follow these steps to establish a cluster and configure cluster parameters in manual mode:
To do… Use the command… Remarks
Enter system view system-view —
Specify the management VLAN management-vlan vlan-id
Required
By default, VLAN 1 is used as
the management VLAN.
Enter cluster view cluster —
Configure a IP address pool for
the cluster
ip-pool
administrator-ip-address
{ ip-mask | ip-mask-length }
Required