H3C Technologies H3C S3600 Series Switches - Manual (Page 1056)

1-5
To do… Use the command… Remarks
Enter system view system-view —
Enable the HWPing
server function
hwping-server enable
Required
Disabled by default.
Configure a UDP
listening service hwping-server udpecho
ip-address port-num
Required for UDP and jitter tests
By default, no UDP listening service is
configured.
Configure a TCP
listening service hwping-server tcpconnect
ip-address port-num
Required for TCP tests
By default, no TCP listening service is
configured.
Note that:
z The HWPing server function is needed only for jitter, TCP, and UDP tests.
z You can configure multiple TCP/UDP listening services on one HWPing server, with each listening
service corresponding to a specific destination IP address and port number.
HWPing Client Configuration
HWPing client configuration
After HWPing client is enabled, you can create multiple test groups for different tests, without the need
to enable HWPing client repeatedly for each test group.
Different types of HWPing tests are somewhat different in parameters and parameter ranges. The
following text describes the configuration on HWPing client for different test types.
Among the test types supported by HWPing, only the ICMP test can be performed when IRF fabric is
enabled; all other test types cannot be performed when IRF fabric is enabled. With IRF fabric enabled,
you are allowed to configure HWPing tests and use the display commands to check your
configurations, but for non ICMP tests, the HWPing tests you configured cannot be executed until fabric
is disabled.
1) Configuring ICMP test on HWPing client
Follow these steps to configure ICMP test on HWPing client:
To do… Use the command… Remarks
Enter system view system-view —
Enable the HWPing client
function
hwping-agent enable
Required
By default, the HWPing client
function is disabled.
Create an HWPing test group
and enter its view hwping administrator-name
operation-tag
Required
By default, no test group is
configured.