H3C Technologies H3C S3600 Series Switches - Manual (Page 1086)

1-35
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
[Sysname-hwping-administrator-tcpprivate] display hwping history administrator tcpprivate
HWPing entry(admin administrator, tag tcpprivate) history record:
Index Response Status LastRC Time
1 4 1 0 2000-04-02 08:26:02.9
2 5 1 0 2000-04-02 08:26:02.8
3 4 1 0 2000-04-02 08:26:02.8
4 5 1 0 2000-04-02 08:26:02.7
5 4 1 0 2000-04-02 08:26:02.7
6 5 1 0 2000-04-02 08:26:02.6
7 6 1 0 2000-04-02 08:26:02.6
8 7 1 0 2000-04-02 08:26:02.5
9 5 1 0 2000-04-02 08:26:02.5
10 7 1 0 2000-04-02 08:26:02.4
For detailed output description, see the corresponding command manual.
UDP Test (Udpprivate Test) on the Specified Ports
Network requirements
Both the HWPing client and the HWPing server are H3C S3600 series Ethernet switches. Perform an
HWPing Udpprivate test on the specified ports between the two switches to test the RTT of UDP
packets between this end (HWPing client) and the specified destination end (HWPing server), with the
port number set to 8000.
Network diagram
Figure 1-9 Network diagram for the Udpprivate test
Configuration procedure
z Configure HWPing Server (Switch B):
# Enable the HWPing server and configure the IP address and port to listen on.
system-view
[Sysname] hwping-server enable
[Sysname] hwping-server udpecho 10.2.2.2 8000
z Configure HWPing Client (Switch A):
# Enable the HWPing client.
system-view