H3C Technologies H3C S3600 Series Switches - Manual (Page 1076)

1-25
# Configure to make 10 probes per test.
[Sysname-hwping-administrator-dhcp] count 10
# Set the probe timeout time to 5 seconds.
[Sysname-hwping-administrator-dhcp] timeout 5
# Start the test.
[Sysname-hwping-administrator-dhcp] test-enable
# Display test results
[Sysname-hwping-administrator-dhcp] display hwping results administrator dhcp
HWPing entry(admin administrator, tag dhcp) test result:
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 1018/1037/1023
Square-Sum of Round Trip Time: 10465630
Last complete test time: 2000-4-3 9:51:30.9
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
[Sysname-hwping-administrator-dhcp] display hwping history administrator dhcp
HWPing entry(admin administrator, tag dhcp) history record:
Index Response Status LastRC Time
1 1018 1 0 2000-04-03 09:51:30.9
2 1037 1 0 2000-04-03 09:51:22.9
3 1024 1 0 2000-04-03 09:51:18.9
4 1027 1 0 2000-04-03 09:51:06.8
5 1018 1 0 2000-04-03 09:51:00.8
6 1020 1 0 2000-04-03 09:50:52.8
7 1018 1 0 2000-04-03 09:50:48.8
8 1020 1 0 2000-04-03 09:50:36.8
9 1020 1 0 2000-04-03 09:50:30.8
10 1028 1 0 2000-04-03 09:50:22.8
For detailed output description, see the corresponding command manual.
You can perform an HWPing DHCP test only when no DHCP client is enabled on any interface.
Otherwise, the DHCP Server sends the response to an interface enabled with the DHCP Client rather
than to the source interface, thus resulting in HWPing DHCP test failure.