H3C Technologies H3C S3600 Series Switches - Manual (Page 814)

1-10
Enabling NDP globally and on specific ports
Follow these steps to enable NDP globally and on specific ports:
To do… Use the command… Remarks
Enter system view system-view —
Enable NDP globally ndp enable
Required
By default, NDP is
enabled globally.
In system view
ndp enable interface
port-list
Enter Ethernet
port view interface interface-type
interface-number
Enable NDP
on specified
Ethernet
ports
In
Ethernet
port view Enable NDP on
the port
ndp enable
Use either approach.
By default, NDP is
enabled on a port.
Configuring NDP-related parameters
Follow these steps to configure NDP-related parameters:
To do… Use the command… Remarks
Enter system view system-view —
Configure the holdtime of
NDP information ndp timer aging
aging-in-seconds
Optional
By default, the holdtime of NDP
information is 180 seconds.
Configure the interval to
send NDP packets
ndp timer hello seconds
Optional
By default, the interval to send NDP
packets is 60 seconds.
Enabling NTDP globally and on a specific port
Follow these steps to enable NTDP globally and on a specific port:
To do… Use the command… Remarks
Enter system view system-view —
Enable NTDP globally ntdp enable
Required
Enabled by default
Enter Ethernet port view
interface interface-type
interface-number
—
Enable NTDP on the Ethernet
port
ntdp enable
Required
Enabled by default
Configuring NTDP-related parameters
Follow these steps to configure NTDP-related parameters: