H3C Technologies H3C S3600 Series Switches - Manual (Page 785)

1-10
To do… Use the command… Remarks
Display port mirroring configuration
on an S3600-SI series Ethernet
switch
display mirror
Mirroring Configuration Examples
Local Port Mirroring Configuration Example
Network requirements
The departments of a company connect to each other through S3600-EI Ethernet switches:
z Research and Development (R&D) department is connected to Switch C through Ethernet 1/0/1.
z Marketing department is connected to Switch C through Ethernet 1/0/2.
z Data detection device is connected to Switch C through Ethernet 1/0/3
The administrator wants to monitor the packets received on and sent from the R&D department and the
marketing department through the data detection device.
Use the local port mirroring function to meet the requirement. Perform the following configurations on
Switch C.
z Configure Ethernet 1/0/1 and Ethernet 1/0/2 as mirroring source ports.
z Configure Ethernet 1/0/3 as the mirroring destination port.
Network diagram
Figure 1-3 Network diagram for local port mirroring
Configuration procedure
Configure Switch C:
# Create a local mirroring group.
system-view
[Sysname] mirroring-group 1 local
# Configure the source ports and destination port for the local mirroring group.
[Sysname] mirroring-group 1 mirroring-port Ethernet 1/0/1 Ethernet 1/0/2 both
[Sysname] mirroring-group 1 monitor-port Ethernet 1/0/3