H3C Technologies H3C S3600 Series Switches - Manual (Page 45)

2-3
Figure 2-4 Set port parameters
3) Turn on the switch. You will be prompted to press the Enter key if the switch successfully
completes POST (power-on self test). The prompt (such as ) appears after you press the
Enter key, as shown in Figure 2-5 .
Figure 2-5 HyperTerminal CLI
4) You can then configure the switch or check the information about the switch by executing the
corresponding commands. You can also acquire help by typing the ? character. Refer to related
parts in this manual for information about the commands used for configuring the switch.