H3C Technologies H3C S3600 Series Switches - Manual (Page 115)

2-5
This section describes how to configure a default VLAN for a trunk or hybrid port.
Follow these steps to configure the default VLAN for a port:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Trunk port port trunk pvid vlan vlan-id Configure
the default
VLAN for the
port
Hybrid port port hybrid pvid vlan vlan-id
Optional
VLAN 1 is the default
VLAN by default.
z After configuring the default VLAN for a trunk or hybrid port, you need to use the port trunk permit
command or the port hybrid vlan command to configure the port to allow traffic of the default
VLAN to pass through. Otherwise, the port cannot forward traffic of the default VLAN, nor can it
receive VLAN untagged packets.
z The local and remote trunk (or hybrid) ports must use the same default VLAN ID for the traffic of the
default VLAN to be transmitted properly.
Displaying and Maintaining Port-Based VLAN
To do… Use the command… Remarks
Display the hybrid or trunk ports display port { hybrid | trunk } Available in any view.
Port-Based VLAN Configuration Example
Network requirements
z As shown in Figure 2-1 , Switch A and Switch B connect to PC 1/PC 2 and Server 1/Server 2 used
by different departments.
z To isolate data between different departments, PC 1 and Server 1 are assigned to VLAN 100 with
the descriptive string being Dept1; PC 2 and Server 2 are assigned to VLAN 200 with the
descriptive string being Dept2.
z Configure VLAN interfaces for the two VLANs on Switch A for forwarding data from PC 1 to Server
2 at Layer 3.