H3C Technologies H3C S3600 Series Switches - Manual (Page 326)

3-11
Figure 3-1 Network diagram for RIP configuration
Device Interface IP address Device Interface IP address
Switch A Vlan-int1 110.11.2.1/24 Switch B Vlan-int1 110.11.2.2/24
Vlan-int2 155.10.1.1/24 Vlan-int3 196.38.165.1/24
Switch C Vlan-int1 110.11.2.3/24
Vlan-int4 117.102.0.1/16
Configuration procedure
Only the configuration related to RIP is listed below. Before the following configuration, make sure the
Ethernet link layer works normally and the IP addresses of VLAN interfaces are configured correctly.
1) Configure Switch A:
# Configure RIP.
system-view
[SwitchA] rip
[SwitchA-rip] network 110.11.2.0
[SwitchA-rip] network 155.10.1.0
2) Configure Switch B:
# Configure RIP.
system-view
[SwitchB] rip
[SwitchB-rip] network 196.38.165.0
[SwitchB-rip] network 110.11.2.0
3) Configure Switch C:
# Configure RIP.
system-view
[SwitchC] rip
[SwitchC-rip] network 117.102.0.0
[SwitchC-rip] network 110.11.2.0