H3C Technologies H3C S3600 Series Switches - Manual (Page 1154)

1-7
Task Remarks
Configuring the Management Address Optional
Setting Other LLDP Parameters Optional
Setting an Encapsulation Format for LLDPDUs Optional
Configuring CDP Compatibility Optional
Configuring LLDP Trapping Optional
Performing Basic LLDP Configuration
Enabling LLDP
To make LLDP take effect on certain ports, you need to enable LLDP both globally and on these ports.
Follow these steps to enable LLDP:
To do… Use the command… Remarks
Enter system view system-view —
Enable LLDP globally lldp enable
Required
By default, LLDP is disabled
globally.
Enter Ethernet interface view
interface interface-type
interface-number
Required
Enable LLDP lldp enable
Optional
By default, LLDP is enabled on
a port.
Setting LLDP Operating Mode
LLDP can operate in one of the following modes.
z TxRx mode. A port in this mode sends and receives LLDP frames.
z Tx mode. A port in this mode only sends LLDP frames.
z Rx mode. A port in this mode only receives LLDP frames.
z Disable mode. A port in this mode does not send or receive LLDP frames.
Follow these steps to set LLDP operating mode:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet interface view
interface interface-type
interface-number
Required
Set the LLDP operating mode
lldp admin-status { disable |
rx | tx | txrx }
Optional
TxRx by default.