H3C Technologies H3C S3600 Series Switches - Manual (Page 761)

1-31
# Configure VLAN mapping on Ethernet 1/0/10 to replace VLAN tag 500 with VLAN tag 100 and replace
VLAN tag 600 with VLAN tag 200.
[SwitchA] interface Ethernet 1/0/10
[SwitchA-Ethernet1/0/10] traffic-remark-vlanid inbound link-group 4002 remark-vlan 100
[SwitchA-Ethernet1/0/10] traffic-remark-vlanid inbound link-group 4003 remark-vlan 200
[SwitchA-Ethernet1/0/10] quit
Define the same VLAN mapping rules on Switch B. The detailed configuration procedure is similar to
that of Switch A and thus is omitted here.
Configuring Traffic Mirroring and Redirecting Traffic to a Port
Network Requirements
A company uses a switch to interconnect all the departments. As shown in Figure 1-12 ,
z The marketing department is connected to Ethernet 1/0/1 of the switch. The IP address segment
for the hosts of the marketing department is 192.168.1.0/25, and the hosts access the Internet
through the switch.
z The R&D department is connected to Ethernet 1/0/2 of the switch. The IP address segment for the
hosts of the R&D department is 192.168.2.0/25, and the hosts access the Internet through the
switch.
z The data monitoring device is connected to Ethernet 1/0/3 of the switch.
Configure traffic redirecting and traffic mirroring to satisfy the following requirements:
z From 8:00 to 18:00 in working days, mirror the HTTP traffic from the marketing department to the
Internet to the data monitoring device.
z From 8:00 to 18:00 in working days, redirect the HTTP traffic from the R&D department to the
Internet to the data monitoring device.
On the data monitoring device, the network administrator can analyze the HTTP traffic from each
department to the Internet.
Network diagram
Figure 1-12 Network diagram for traffic redirecting and traffic mirroring configuration
Configuration procedure
1) Define a time range for working days