H3C Technologies H3C S3600 Series Switches - Manual (Page 1053)

1-2
Figure 1-1 HWPing illustration
Test Types Supported by HWPing
Among the test types supported by HWPing, only the ICMP test can be performed when IRF fabric is
enabled; all other test types cannot be performed when IRF fabric is enabled.
Table 1-1 Test types supported by HWPing
Supported test types Description
ICMP test
DHCP test
FTP test
HTTP test
DNS test
SNMP test
For these types of tests, you need to configure the HWPing
client and corresponding servers.
Jitter test
Tcppublic test
TCP test
Tcpprivate test
Udppublic test
UDP test
Udpprivate test
z These types of tests need the cooperation of the HWPing
client and HWPing server.
z Do not perform a TCP, UDP or jitter test on a well-known port
(ports with a number ranging from 1 to 1023). Otherwise,
your HWPing test may fail or the service corresponding to the
well-known port may become unavailable.
HWPing Test Parameters
You need to configure corresponding test parameters for each type of HWPing test. HWPing test
parameters can be configured on HWPing client only. For the configurations on the HWPing client, refer
to section HWPing Client Configuration .
Table 1-2 HWPing test parameters
Test parameter Description
Destination address
(destination-ip)
For a TCP/UDP/jitter test, you must specify a destination IP address, and
the destination address must be the IP address of a TCP/UDP/UDP
listening service configured on the HWPing server.
Destination port
(destination-port)
For a tcpprivate/udpprivate/jitter test, you must specify a destination port
number, and the destination port number must be the port number of a
TCP or UDP listening service configured on the HWPing server.